Inflate Bag repair - quick fix

Mods, DIY gear, repair, etc...
Post Reply
JHypers
Posts: 16
Joined: Sat Oct 15, 2011 11:52 am

Inflate Bag repair - quick fix

Post by JHypers » Tue Oct 25, 2011 2:03 am

This may not be an issue for most folks, but occasionally (as was the case with yours truly) packrafters may encounter a situation where their inflate bag fails in field, provoking hideous thoughts of having to blow it up solely with their lungs...and since I'd wager most river-runners don't have the same VO2 max as Ed Viesturs or Lance Armstrong, this option will take a bit of time and energy. One bad scenario is that the valve connector detached from the silnylon, unable to be re-seated as designed.

Not to worry. The following will solve this problem in a matter of seconds.

1) take valve connector and drop it inside the bag.
2) reach inside an grab it, with the threads facing towards the hole at the bottom.
3) force the bottle-neck of silnylon over and around the threads, pushing/pulling as needed to expose as much of the threading as possible.

There ya have it. The piece is fixed in-place (just don't turn it inside-out), and despite some of the threading inevitably still covered by the silnylon, it will still screw tightly onto the raft valve. Check the side stitching on the bottle neck for any weak points, and go try it out. I've found that, for me at least, it's easier to push the air through with this set-up. Obviously don't wreck your perfectly good inflate bag to see if I'm right or wrong, but if you are considering buying a new bag on account of this precise problem, save your money.

andrewallan
Posts: 217
Joined: Sun Sep 02, 2007 9:56 pm
Location: Melbourne, Australia

Re: Inflate Bag repair - quick fix

Post by andrewallan » Sun Oct 30, 2011 1:29 am

I've not ever had an issue with inflation bag failing.

However, your post does raise some issues with inflation bags. They are very easy to make....basic sewing skills only.

The screw fitting is a standard plumbing fitting with some pipe pushed inside to hold it together. Today I made a roll top dry bag for my packrafting pack, but with an inflation valve fitting on the bottom, with screw cap closure----- dual use.

AA

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest