Pumps and pressure.

Mods, DIY gear, repair, etc...
Post Reply
Posts: 3
Joined: Tue Oct 02, 2012 12:05 pm

Pumps and pressure.

Post by TheRunningGuy » Thu Jan 31, 2013 11:50 am

Just tossing this on out there. I had the idea of drilling a hole in the packraft cap and mounting a Schrader valve into it. That would let you use a bike pump to inflate the raft. Don't think you would gain inflation speed but you could get a higher pressure. Just wondering what extra pressure would mean out on the water and what dangerous pressure might look like.

Stupid idea I know... or is it?

PS, Greenland paddles work well with a packraft on open water but a sliding/race stroke spins you too much.


Posts: 156
Joined: Tue May 01, 2012 9:32 pm

Re: Pumps and pressure.

Post by jeremy089786 » Tue Mar 05, 2013 11:28 pm

Hi Nathan,

Not a bad idea at all. I have drilled a hole in my plug and inserted a long hose so I can inflate/ temper without getting out of the boat and a valve like that would probably work equally well. I would worry about anything likely to corrode though. I can't really comment on pressure, but it may or may not lead to busted seams (?) though I think the seams in some packrafts are stronger than the actual material (again a ?)

Posts: 2
Joined: Sat Dec 29, 2018 7:40 am

Re: Pumps and pressure.

Post by ooi21 » Sat Dec 29, 2018 7:48 am

Hello Everyone,

I am looking for a pump for my swimming pool. I am slightly confused which one to buy as there are a lot of companies with different specification. Which pump should I buy? Please help me.


Post Reply